Caple CR 1207 Instruction Manual page 25

Lighting gas burners fit-
ted with flame failure
safety device
(Auxiliary, Semi-rapid and triple
ring burners)
In order to light the burner, you must:
1 – Push and turn the knob in an anti-
clockwise direction up to the
position (maximum rate), push in
and hold the knob until the flame
has been lit (fig. 4.3).
The sparks produced by the lighter
situated inside the relative burner
will light the flame.
In the event that the local gas sup-
ply conditions makes it difficult to
light the burner in
again with the knob in
If there is no mains electrical sup-
ply, bring a lighted match close to
the burner.
2 – Wait for about ten seconds after
the gas burner has been lit before
letting go the knob (safety device
activation delay).
3 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will
automatically stop the gas flow.
To re-light the burner, return the knob
position, wait for at
to the closed
•
least 1 minute and then repeat the
lighting procedure.
position, try
position.
Fig. 4.3
N.B. When the cooker is not being
used, set the gas knobs to their
positions and also close the gas
shut-off valve placed on the main
gas supply line.
Caution!
The cooker becomes very hot
during operation.
Keep children well out of reach.
•
25