Advertisement
Operations
. The STANDBY indicator lights up. This means that
the receiver is not disconnected from the AC mains
and a small amount of current is retained to support
the memorized contents and operation readiness.
. To switch the power off, push the POWER switch
again.
. Then the power is cut off and the STANDBY
indicator goes off.
ir,'
n
lh
U
6l
"t"""n"
oesired inPut source
. Each time the INPUT SELECTOMNDEX knob is
rotated, the input source changes as follows I
T
PHoNo * TUNER -
CD PLAYER
-
TAPE I *l
|
(frequency displayr
I
L. AUVTV *
VCRI *
LD PLAYER -
DVD J
. When the TAPE 2 MONITOR burron is ser to on so
that -TAPE 2M" indicator lights up, other inputs
can not be heard from the speakers.
To listen to a input source other than TAPE 2
MONITOR, be sure to set the TAPE 2 MONITOR
button to off.
TAPE 2 MONITOR function
You can connect either a tape deck or a graphic
equalizer to the receiver's TAPE 2 MONITOR jacks.
Only when you listen to the component connected to
thesejacks, ser the TAPE 2 MONITOR burton ro on
If you connect a 3-head tape deck, you can listen to the
sound being recorded dufing recording, not the source
sound,
For funher details, refer to the operating instructions
of the component connected-
When the AUXTV is selected as input source
. Select the front AUX/VIDEO or the rear TV/AUX.
If the tiont AUX/VIDEO is selected, the FRONT
AUX indicator lights up.
5ffi
t-r
E
t-r
E
E
ln the standby mode, tum the power on.
. Each time the STANDBY button on the recever or
the POWER button on the remote cont.ol is pressed,
the receiver is tumed on to enter the operating mode
or off to enter the standby mode
. ln the standby mode, if the INPUT SELECTOR
button is pressed on the remote confol, the receiver
is tumed on automatically and the desired input is
selected.
56ffi
E
t-r
O'*"'n^'':6t::""
b
. Then sound can be heard from the speakers
connected to the speaker terminals.
. When using the headphone for private listening,
press the SPEAKER swirch again to switch the
speakers off.
E
Advertisement
