Playing Analog Multichannel Audio - Integra DTR-7.4 Instruction Manual

Enjoying Analog Multichannel Audio Playback—Continued

Playing Analog Multichannel Audio

Before enjoying analog multichannel audio, make sure
that the connections and settings shown on the previous
page are completed.
The illustrations used here represent the remote control-
ler. When you perform the procedures on the DTR-7.4,
use the corresponding buttons on the front panel.
1 Press the Input button, and then
Input
roll the scroll wheel to select
"DVD."
2
Press the scroll wheel, and then
press the Audio SEL button
repeatedly to select "Multich."
On the DTR-7.4, use the Audio
Selector button.
Audio SEL
3 Turn on the connected component
and start playing the desired media.
4 Adjust the volume with the Master
Volume dial (or the VOL
VOL tons on the remote controller).
Adjusting the output level of each speaker as desired
Using the remote controller:
1 Press the scroll wheel.
2 Press the CH SEL button and
CH SEL
select the desired speaker.
3 Press the Level – or + button to
adjust the volume level.
Level - Level +
Adjust the volume at each speaker so that
all the volumes sound at the same level at
the listening position. For the front right,
front left, center, surround right, sur-
round left, surround back right, and sur-
round back left speakers, the output
levels can be adjusted between –12 and
+12 decibels. The subwoofer can be
adjusted between –30 and +12 decibels.
Note:
The speaker level for each multichannel analog input is
independent from the speaker level settings made with
the test tone. Therefore, you should perform the proce-
dures above before enjoying analog multichannel audio.
Changing the listening mode
Pure A Direct
Using the tone control
1
DTR-7.4
Surround
Remote
controller
Surround
2
but-
To disable the tone control function:
Press the Direct/Pure Audio button on the front panel (or
the Direct button on the remote controller).
Each time you press the Direct/
Pure Audio button on the front
panel, the display changes
between "Direct" "Pure
Audio." When using the remote
controller, press Pure A or Direct.
Press the Surround button on the
front panel or the remote control-
ler to display "Tone On."
Adjust the bass and treble sounds.
Select "Setup Menu" → "Audio Adjust
Menu" → "Tone Control" to display the
"Tone Control" sub-menu and perform
the bass and treble settings. For details,
see page 54.
65