DTR-6.5,5.5_En.book Page 45 Wednesday, July 28, 2004 9:07 AM
First Time Setup —Continued
TV Format Setup (not American models)
Here you can specify the TV format used in your area.
1
Press the [Receiver] button fol-
Receiver
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "1. Initial
Setup," and then press [Enter].
The Initial Setup menu appears.
3
Use the Up and Down [
buttons to select "3. Hardware
Setup," and then press [Enter].
Enter
The Hardware Setup menu appears.
Menu
------------------------
Basic Setup
1.Initial Setup
1.Initial Setup
------------------------
2.Speaker Setup
1.Digital Input
1-3.Hardware Setup
Enter
2.Component Video
------------------------
Advanced Setup
3.Hardware Setup
a.Powered Zone2
3.Surround Setup
4.Audio Adjust
b.Zone2 Out
5.Listening Mode Preset
6.Preference
c.Sp Impedance Minimum
d.TV Format
(Menus vary depending on country.)
4
Use the Up and Down [
buttons to select "c. TV Format,"
and then use the Left and Right
Enter
[
]/[
] buttons to select:
Auto: Conforms with the video
input signal.
PAL: Select if the TV system in
your area is PAL.
NTSC: Select if the TV system in
your area is NTSC.
5
Press the [Setup] button.
The setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
]/[
]
]/[
]
:Not Activated
:Fixed
:6ohms
:AUTO
]/[
]
45