Connecting The Power Cords Of Other Components; Connecting The Supplied Power Cord; Turning On The Av Receiver - Integra DTR-5.5 Instruction Manual

DTR-6.5,5.5_En.book Page 38 Wednesday, July 28, 2004 9:07 AM
Connecting the AV receiver —Continued
Connecting the Power Cords of Other
Components
The AV receiver has AC outlets on its rear panel that can
be used to connect the power cords of AV other compo-
nents that you intend to use with the AV receiver. These
components can then be left turned on so that they turn
on and off as and when the AV receiver is turned on and
set to Standby.
AC OUTLETS
AC 120 V 60 Hz
SWITCHED
TOTAL 120W 1A MAX.
Caution:
• Make sure that the total capacity of the components
that you connect to the AC OUTLETS does not exceed
the stated capacity (e.g., TOTAL 120 W).
Note:
• Integra components with
nected directly to wall outlets, not the AV receiver's
AC OUTLETS.
• The number of AC OUTLETS, socket type, and total
capacity depends on the country in which you pur-
chased the AV receiver.
Connecting the RS232 Port
This port can be used to connect an external controller
for controlling the AV receiver.
38

Connecting the Supplied Power Cord

Plug the supplied power cord into this AC INLET.
• Do not use a power cord other than the one supplied
• Never disconnect the power cord from the AV receiver

Turning On the AV receiver

jacks should be con-
Notes:
• Pressing the remote controller's [On] button once will
• When the AV receiver is on Standby, it will turn on
with this AV receiver. It's designed exclusively for use
with this AV receiver and should not be used with any
other component.
while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first.
AC INLET
DO NOT connect the
power cord at this time.
Power cord
(supplied)
Standby/On
Zone 2
Standby
Press the [Standby/On] button.
Alternatively, press the remote
controller's [Receiver] button fol-
lowed by the [On] button.
The AV receiver comes on, the display
Remote
controller
lights up, and the Standby indicator
On goes off.
Standby
To turn off the AV receiver, press the
[Standby/On] button. The AV receiver
will enter Standby mode.
turn on the AV receiver. Pressing it again will turn on
any components connected via
automatically when any one of its input selector but-
tons is pressed.
On
Standby
On Standby
T V
I Input
V 1 V 2 V 3
+
1 2 3
V 4 Multi CH DVD T V CH
4 5 6 -
C D Tape Tuner
7 8 9
Phono TV VOL
+10 0 Clear
--/---
.