First Time Setup; Automatic Speaker Setup; First Setup - Integra DTR-5.5 Instruction Manual

DTR-6.5,5.5_En.book Page 39 Wednesday, July 28, 2004 9:07 AM

First Time Setup

This chapter explains the settings that you need to make before using the AV receiver.

Automatic Speaker Setup

With the supplied speaker setup microphone, the Auto-
matic Speaker Setup function can measure the test tone
output by each speaker and automatically determine the
number of speakers connected, their sizes, the distance
from each speaker to the listening position, and so on.
Before using this function, connect and position all your
speakers.
On Standby
Zone 2 V 1
Standby
1
V 4 Multi CH
4
C D
7
Phono
+ 10
--/---
Input Selector
Macro
1
1 2
Receiver
Tape
T V
Dimmer
3–7
TV
Input
+
CH
Disc
-
Prev
CH
Display
1 Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
T V
I Input
V 2 V 3
+
2 3
T V CH
DVD
-
5 6
Tape Tuner
8 9
TV VOL
0 Clear
2 3 Zone 2
Remote Mode
DVD C D MD/CDR
VCR Cable SAT
Sleep
VOL
Enter
Muting
2
Put the speaker setup micro-
phone in the listening position,
and connect it to the Setup Mic
jack.
Auto Speaker Setup
------------------------
Push Enter:Start
Notes:
• Wait at least five seconds after turn-
ing on the AV receiver before plug-
ging in the speaker setup
microphone.
• Make sure the microphone is hori-
zontal.
• If there's an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set the room how you would
have it when enjoying a DVD.
• If the AV receiver was previously
muted, the Muting function will be
cancelled.
• The automatic setup cannot be used
while a pair of headphones is con-
nected.
• By putting the microphone close to
where your ears would normally be
at the listening position, a more accu-
rate setup can be achieved. If you use
a tripod or level table, you can adjust
the height of the microphone.
MIC
position
39