Connecting Video Components; Connecting A Dvd Player - Kenwood KRF-V6030D Instruction Manual

Connecting video components

PLAY IN REC OUT PLAY IN PLAY IN PLAY IN
S-VIDEO
DVD VIDEO 1 VIDEO 1 VIDEO 2 VIDEO 3
REC OUT PLAY IN PLAY IN PLAY IN
VIDEO 1 VIDEO 2 VIDEO 3
OUT OUT
OUT
OUT
IN
Audio inputs and outputs
VIDEO IN
Video Inputs
(Yellow RCA pin cord)
About the S VIDEO
jacks
REC OUT
S VIDEO
MONITOR
Use the S VIDEO jacks to
make connections to video
components with S VIDEO
IN/OUT jacks.
÷ If you use the S VIDEO
jacks to connect your video
playback components, be
sure to use the S VIDEO
jacks when connecting your
monitor and video record-
ing components.
VIDEO
OUT
IN
OUT
Video inputs
and outputs
(Yellow RCA pin
cords)
Connecting a DVD player (6-channel input)
If you have connected a DVD player to the receiver with digital connection,
be sure to read the "Input mode settings" section on the following page
carefully.
PLAY IN
L
S VIDEO
DVD
R
FRONT
DVD/6ch INPUT
S VIDEO
cord
S VIDEO
OUT
FRONT SURROUND
OUT L/R OUT L/R
VIDEO OUT COAXIAL
(Yellow RCA DIGITAL
pin cord) OUT
(AUDIO)
CAUTION
Be sure to adhere followings. Or proper ventilation will be blocked
causing damage or fire hazard.
• Install the KRF-V7030D/V6030D/V5030D/V4530D on the top of the
system.
• Do not place any objects impairing heat radiation onto the top of unit.
• Leave a space around the unit (from the largest outside dimension
including projection) equal or greater than, shown below.
Top panel : 50 cm Side panel : 10 cm
Setting up the system
CENTER DVD
SURROUND SUB WOOFER VIDEO 2
COAXIAL
VIDEO
CENTER OUT
SUBWOOFER OUT
Back panel : 10 cm
9