Connecting Video Components; Connecting A Dvd Player - Kenwood KRF-V7030D Instruction Manual

Connecting video components

S Video jacks
(KRF-V7030D only)
PLAY IN REC OUT PLAY IN PLAY IN PLAY IN
S-VIDEO
DVD VIDEO 1 VIDEO 1 VIDEO 2 VIDEO 3
(KRF-V7030D
only)
REC OUT PLAY IN PLAY IN PLAY IN
VIDEO 1 VIDEO 2 VIDEO 3
OUT OUT
DVD player or LD player
OUT
DVD player or LD player
Video deck
OUT
IN
Audio inputs and outputs
Monitor TV
VIDEO IN
Video Inputs
(Yellow RCA pin cord)
A video component with digital audio outputs should be con-
nected to the VIDEO2 or VIDEO3 (KRF-V7030D only) jacks.
About the S VIDEO
jacks
REC OUT
S VIDEO
MONITOR
Use the S VIDEO jacks to
make connections to video
components with S VIDEO
IN/OUT jacks.
÷ If you use the S VIDEO
jacks to connect your video
playback components, be
sure to use the S VIDEO
jacks when connecting your
monitor and video record-
ing components.
(KRF-V7030D
only)
VIDEO
OUT
IN
OUT
Video inputs
and outputs
(Yellow RCA pin
cords)
Connecting a DVD player (6-channel input)
If you have connected a DVD player to the receiver with digital connection,
be sure to read the "Input mode settings" section on the following page
carefully.
PLAY IN
L
S VIDEO
DVD
R
FRONT SURROUND
DVD/6ch INPUT
S VIDEO
cord
DVD player
S VIDEO
OUT FRONT SURROUND
OUT L/R OUT L/R
VIDEO OUT COAXIAL
(Yellow RCA DIGITAL
pin cord) OUT
(AUDIO)
To switch the speakers off , press the MUTE key.
CAUTION
Be sure to adhere followings. Or proper ventilation will be blocked
causing damage or fire hazard.
• Install the KRF-V7030D/V6030D/V5030D/V4530D on the top of the
system.
• Do not place any objects impairing heat radiation onto the top of unit.
• Leave a space around the unit (from the largest outside dimension
including projection) equal or greater than, shown below.
Top panel : 50 cm Side panel : 10 cm
Setting up the system
CENTER DVD
SUB WOOFER VIDEO 2
COAXIAL
VIDEO
CENTER OUT
SUBWOOFER OUT
Back panel : 10 cm
9