To Clean The Inner Glass Door Panels; To Replace The Inner Glass Door Panels - AEG COMPETENCE D8100-1 Operating Instructions Manual

TO REMOVE THE MIDDLE GLASS
6) To remove the middle door glass repeat steps
1 - 3 as page 38.
7) Then, lift glass clear of handle.
Note:
Plastic end caps can be removed for cleaning.
8) Close the oven door.
TO CLEAN THE INNER AND MIDDLE
GLASS DOOR PANELS
Clean the inner door glass panels using a soft cloth and
hot water to which a little washing up has been added.
If the inner panel is heavily soiled, Hob Brite may be
used. Do not use abrasive cleaning materials on the
door glass. Ensure that all parts are well rinsed and
thoroughly dried before attempting to replace the glass.
Do not clean stainless steel outer panels
(where fitted) with Hob Brite as damage to
the finish will
instructions for stainless steel models on
page 36.
TO REPLACE THE MIDDLE AND
GLASS PANELS
1) Ensure plastic end caps are in place on the middle
glass.
Note: This is the smaller of the two pieces of glass.
Top oven door glass must have the angled corners
facing towards the bottom of the door when refitted.
2) Holding the glass panel with your right hand fully
open the oven door with your left hand.
3) Gently place the middle glass in the door recess, the
plastic end strips will evenly space the middle glass
from the outer.
4) Holding the door fully open pick up the door
inner glass.
5) Gently ease and push the glass into the location
points under the handle before lowering and sliding
the glass into position under the hinge location points
at the rear.
6) Ensure that the glass is properly located and that the
text 'This way up' is facing towards you and at the
top edge of the door.
Do not attempt to use the oven without
the glass being in place.
occur. See cleaning
INNER
39