To Remove The Inner Glass; To Clean The Inner Glass Door Panels; To Replace The Inner Glass Panel - AEG COMPETENCE D2100-4 COMPETENCE D2100-4B Installation And Operating Instructions Manual

TO REMOVE THE INNER GLASS

1. Fully open the oven door.
2. Firmly grasp the rear edge of the inner glass panel
with both hands.
3. Push the glass panel towards you until it clears
the hinge location points at the rear.
4. With one hand, carefully lift the glass panel to
disengage it from the location points under the
handle. (With your other hand, hold the outer
door to ensure it does not spring shut on
removing the inner panel).
5. Close the oven door.
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner door glass panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled, Hob
Brite may be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all parts are
well rinsed and thoroughly dried before attempting to
replace the glass.
Do not clean stainless steel outer panels
(where fitted) with Hob Brite as damage to
the finish will occur.

TO REPLACE THE INNER GLASS PANEL

1. Holding the glass panel in your right hand fully
open the oven door with your left.
2. Gently ease and push the glass into the location
points under the handle before lowering and
sliding the glass into position under the hinge
location points at the rear.
Ensure the glass is properly located and the text 'This
way up' is facing towards you and at the top edge of
the door.
Do not attempt to use the oven without the
glass being in place.
24