Cleaning Inside The Ovens; Cleaning The Door Glass; To Remove The Inner Glass; To Clean The Inner Glass Door Panels - AEG COMPETENCE D2160-1 Operating Instructions Manual

CLEANING INSIDE THE OVENS

The vitreous enamel coating in the ovens can be
cleaned using normal oven cleaners or aerosol oven
cleaners with care. Ensure that the manufacturers
instructions are followed and that all parts are well
rinsed afterwards.
Aerosol cleaners must not come into
contact with elements or the door seal as
this may cause damage.

CLEANING THE DOOR GLASS

To prevent damaging or weakening of the
door glass panels avoid the use of the
following:
· Household detergents and bleaches
·
Impregnated pads unsuitable for non-
stick saucepans
·
Brillo/Ajax pads or steel wool pads
·
Chemical oven pads or aerosols
·
Rust removers
·
Bath/Sink stain removers
The main oven and second oven inner door glass
panels are removable for cleaning.
Under no circumstances should the door
assembly be detached from the product for
cleaning. Please refer to the cleaning
instructions.

TO REMOVE THE INNER GLASS

1. Fully open the oven door.
2. Firmly grasp the rear edge of the inner glass panel
with both hands.
3. Push the glass panel towards you until it clears
the hinge location points at the rear.
4. With one hand, carefully lift the glass panel to
disengage it from the location points under the
handle. (With your other hand, hold the outer
door to ensure it does not spring shut on
removing the inner panel).
5. Close the oven door.
If the door glass panel becomes chipped or
has deep scratches the glass will be
weakened and must be replaced to prevent
the possibility of the panel shattering.
Please contact your local Service Force
Centre who will be pleased to advise
further.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner door glass panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled, Hob
Brite may be used. Do not use abrasive cleaning
materials on the door glass. Ensure that all parts are
well rinsed and thoroughly dried before attempting to
replace the glass.
25