Paradise Datacom Vision Series Installation And Operating Handbook page 78

Edit-Unit-Interface-Terrestrial-IP
./Interface/IP/Traffic port IP netm ask:
New :[255.255.000.000]
Factory default:
Sets the IP subnet mask for the IP Traffic card.
Description:
Edit-Unit-Interface-IP-
./Interface/IP/Traffic port IP gatew ay:
New :[010.000.070.003]
Factory default:
Sets the IP address of a default gatew ay for the IP Traffic card. The
Description:
gatew ay represents the 'next hop' destination, w hich is normally the
address of a router, for packets destined for somew here other than the
local netw ork. This is used w ith TCP acceleration, brouting and header
compression. An address of 0.0.0.0 means that the gatew ay is not set. In
straight bridging mode it is not nor mally necessary to set this gatew ay as
the bridge automatically learns the location of each device.
Note that there are two gatew ays that can be defined in the m odem .
The Traffic Port IP Gateway is used exclusively in relation to the IP
Traffic card. The Remote Control Port IP Gateway (on the Edit-Unit-
M&C-IP menu) w ill be used in relation to the M&C network and the
Rem ote M&C Ethernet port.
Vision Series Installation and Operating Handbook
-Traffic Port IP Netm ask Screen
[255.255.255.255]
255.255.255.255
Traffic Port IP Gateway Screen
[0.0.0.0]
0.0.0.0
7-57