Paradise Datacom Vision Series Installation And Operating Handbook page 65

This menu contains the follow ing options:
ASI. This allow s each of the ports of the Quad ASI interface card to be set to Tx, Rx or
•
Off. Any port that is not sw itched off will be routed through to the main traffic channel
of the modem for transmission or reception from satellite, as selected.
RF. This option is used to set the RF port impedance.
•
Edit-Unit-Interface-ASI Menu
Edit/Unit/Interface/ASI:
Each of the options on thi s menu controls the respective port of the Quad ASI card as
described in the follow ing screen.
Edit-Unit-Interface-ASI-Port Screen
Edit/Unit/Interface/ASI/Port 1 mode:
New :[Out]
Options:
In (Note this may be show n as Tx in earlier versions of the software)
Sets the respective port of the Quad ASI card to enable it to receive input
data to be transmitted to the satellite. If the modem is set to allow
multistreaming then the data w ill be inter leaved w ith any other port on the
Quad ASI card that is enabled as Tx, as w ell as any other terrestrial
interface card that is enabled.
Out (Note this may be show n as Rx in earlier versions of the software)
Sets the respective port of the Quad ASI card to enable it to transmit data
received from satellite onto the terrestrial netw ork. If the modem is set to
allow multistreaming then data w ill be deinterleaved from the multiplexed
receive carrier and passed to the appropriate ASI port. Data can either be
passed betw een the same ports at each end of the link (i.e. Tx port 1 to Rx
port 1, Tx port 2 to Rx port 2, etc.) or data can be filtered based on PID
identifier or ISI identifier.
Vision Series Installation and Operating Handbook
1Port 1 2Port 2
3Port 3 4Port 4
[In]
7-44