Paradise Datacom Vision Series Installation And Operating Handbook page 77

Edit-Unit-Interface-Terrestrial-Enable Default RIP Configuration
./Interface/IP/Enable default RIP configuration:
New :[Disable RIP]
Options:
Use RIP enabled default
Turns on the RIP dynamic routing protocol by setting a default configuration
that w ill be sufficient in most cases. The configuration can be further tuned,
if required,
http://www.paradisedata.com//w
Disable RIP
The RIP dynamic routing protocol is turned off. Note: this w ill overwrite any
existing configuration, including any modified as specified above (see the
TCP/IP w hite paper at
more details).
Factory
Disable RIP
default:
Description: This option is available in routing mode.
Edit-Unit-Interface-IP-
./Interface/IP/Traffic port IP address:
New :[010.000.070.002]
Factory default:
Sets the IP address for the IP Traffic card. Both of the Ethernet ports on
Description:
the IP Traffic card use this same address and can be used
interchangeably. Unlike the base modem Remote M&C port, DHCP is
not supported and therefore an address must be manually entered. The
traffic port IP address is not directly used in straight bridging mode
(although the address must be a valid one for the local network in point-
to-point bridging mode). The IP address is how ever used in modes using
TCP acceleration and header compression.
Vision Series Installation and Operating Handbook
[Disable RIP]
as specified
http://www.paradisedata.com//w hitepapers.php
Traffic Port IP Address Screen
[0.0.0.0]
0.0.0.0
in the TCP/IP
hitepapers.php.
7-56
w hite paper at
for