MAINTENANCE
Bar blade assembly:
1.
Tip the lawnmower with its spark plug upward - refer to engine manual.
2.
Remove the centre bolt and spring washer; pull the blade and carrier off the engine
shaft.
3.
Either sharpen and balance the old blade or fit a new one.
4.
Grease the engine shaft; assemble in reverse order ensuring the drive key is located
correctly.
5.
Torque the centre bolt to 50 Nm.
Blade Replacement Torque Settings:
Centre Bolt 50 Nm
Flail Blade Bolts 20 Nm (free to move)
Carburettor Adjustment:
Check your engine Manufacturers Maintenance Instructions when carburettor adjustment is
required to compensate for changes in fuel, temperature, altitude or load.
20