Handlebar Folding Instructions; Handlebar Height Adjustments Instructions; Mulch Models - Bushranger 500SF Assembly And Owner's Manual

COMMISSIONING THE LAWNMOWER

Handlebar folding instructions:

The handlebar assembly is supplied in the storage
position for packaging purposes. The folding handle
system allows for compact storage when not in use.
• Unfold the handle by lifting and turning it to
its 'mowing' position.
• Lock the handlebar in this position before
operating the mower by activating the
locking lever. The locking lever can be locking
in place at any point throughout its 360-degree
movement.
• On models fitted with 'zone start' facility, pull
the engine starter cord out carefully so that
there is sufficient length to extend the handle
fully without stretching the cord.
To change the handlebars back to the storage position,
simply loosen the handle locking lever and rotate the
upper handlebar forward over the mower body.
There are two locking levers on 500SF and 650SF models.
Handlebar Height adjustment instructions:
The height of the handlebar can be adjusted to various heights.
Lift the grass flap and secure it in the open position, loosen the four bolts two on each side
holding the handle to the mower.
• The handle can now be adjusted to the correct height by moving it.
• Hold the handle in place and tighten the bolts to secure the handle in its new position.
Mulch & Catch models:
Always wait until the engine has
stopped and the blade has stopped rotating
before fitting or removing the Mulcher plug.
The mulching lawnmowers have been
assembled ready for mulching mode. They
have the mulching plug inserted and the
correct blade system fitted. Removal of the
mulcher plug and fitting the catcher converts
the mower to a catching model and vice
versa.
10