Air Shutter Adjustment - Lopi Berkshire GS2 Owner's Manual

24
5. Install the logs (see page 27).
6. Replace the glass.
7. Start the heater.
8. Leak test all gas joints.
9. Check the air shutter following the directions below.

Air Shutter Adjustment

Let the heater burn for fifteen minutes (make sure the logs and glass are in place). The flames should be
yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
10. Turn the flame adjust knob to its highest position - the flames should not contact the top of the firebox. Check
the flame on low position. The flames should burn off of each burner hole. If the heater does not work
correctly, contact your Travis dealer for a remedy.
11. Give this manual to the home owner for future reference and fully explain operation of this heater.
© Travis Industries
Installation
(for qualified installers only)
4121129 100-01314