Power Switch - Bunn Axiom Series Service & Repair Manual

MASTER ON/OFF SWITCH
FIG. 26-1 MASTER ON/OFF SWITCH
Location:
The rocker switch is located on the left side of
the trunk behind the front access panel on some
earlier models. The toggle switch on later models is
located on the back of the trunk.
Test Procedure:
1. Disconnect the brewer from the power source.
2. Disconnect the wires from the power switch. With
the switch in the ON position, check for continuity
between the upper and lower terminals on each
side of the switch.
There should be continuity between the two left ter-
minals and between the two right terminals when ON,
no continuity when OFF.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Disconnect the brewer from the power source.
2. Disconnect the wires from the power switch.
3. Remove the switch mounting screws from the left
side of trunk.
4. Install new switch in trunk with the two 6-32 x ¼˝
mounting screws.
FIG. 26-2 TOGGLE SWITCH LOCATION
FIG. 26-3 ROCKER SWITCH
Page 26
L2
L1
39132 052410