Log Placement; Rock Wool Placement - Vermont Castings VC31LDVINTSC Installation And Operating Instructions Manual

lOG plACemeNt

Before you begin - This unit is supplied with seven (7)
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
INstAll lOGs AND ROCK WOOl (emBeR
mAteRIAl) IN FIReBOx
1. Break up rock wool (ember material) into small fluffy
pieces. Place evenly as shown. Refer to Figure 23.
2. Apply a light layer of embers to the ports. NOte:
Excessive amount of embers will affect the flame and
the flame appearance. NOte: Embers may be added
to entire burner area in front of grate to hide burner and
log support brackets.
Figure 23 -
Ember Material Area
Ember Material
20304166
LG1123
CFDVI embers
VC31LDVI/VC31CDVI Gas Fireplace Insert
the positioning of the logs is critical to
the safe and clean operation of this heater.
sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may
result in property damage or personal in-
jury.
Ember Material Area
Ember Material Area
LG1131
ember material placement
LG1123
LG1132
Do not use the entire bag
of rock wool to cover
burner area.
21