Service And Repair - Bosch Nexxt Operating, Care And Installation Instructions Manual

Problem
Degree of drying has not been reached
or the drying time is too long. y g g
Display may indicate E:03".
Drum light does not function. g
Start/Stop" indicator light does not
illuminate. Lint filter" indicator light
flashes. wrinkle block/finished" flashes wrinkle block/finished"
indicator lights.
The display shows 000".

SERVICE and REPAIR

d
CAUTION
CAUTION - Label all wires prior
to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous
operation. verify proper
operation after servicing.
The Bosch dryers require no special
care other than the care and
cleaning noted above.
If you are having a problem with
i
your dryer, before calling for
service please refer to Table on
page 24, following.
If service becomes necessary,
contact your dealer or installer or an
authorized service center. Do not
attempt to repair the appliance
yourself. Any work performed by
unauthorized personnel may void
the warranty.
Possible cause
Lint filter dirty.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
No program selected.
Liightbulb defective, lightbulb burned out.
No power supply.
Fault in program sequence or malfunction.
If you are having a problem with
your Bosch dryer and are not
d
pleased with the service you have
received:
- First, please contact your
installer or the Bosch
Authorized Service Contractor
in your area and explain to
them why you are not satisfied.
This will usually correct the
problem.
- If after working with your
installer or service person the
problem still has not been
resolved to your satisfaction,
please let us know by either
writing to us at,
BSH Home Appliances
5551 Mc Fadden Avenue
Huntington Beach, CA 92649
or, calling us at
1 800 944 2904.
Remedial action
Clean filter as described on page 23.
Switch off/switch on again.
Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Select program with aid of the program selection
table (see page 19). Switch off/switch on again.
Clean lint filter (see page 23).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
Select program.
Change light bulb, see page 24.
Guarantee power supply.
Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program. Restart program
Please be sure to include, if writing,
or have available, if calling, the
following information:
- Model Number
- Serial Number
- Date of Original Purchase
- Date Problem Originated
- Explanation of Problem
Also, if writing, please be sure to
include a daytime telephone
number and a copy of the sales
invoice.
You will find the model number and
serial number information on the
rating plate located on the inside of
the front panel.
25