Star LC-1511 User Manual page 26

15
Metal edge
Bord métallique
Metallkante
Bordo di metallo
Grasping the two back corners of the printer with
the palms of your hands, press back on the two
raised areas on the top of the rear cover until it
opens.
Swing the rear cover back and down until it stops.
Note:
You can also completely remove the rear cover by
simply pulling it away from the back of the printer
after you open it.
Caution!
The metal edge of the cover is rather sharp. Take
care to avoid injuring your hands when handling it.
Pass the fanfold paper through the space between
the printer case and the rear cover.
Unlock the two tractor covers by pulling their
gray levers up, and slide them so they are aligned
approximately with the holes on the sides of the
paper. Also move the center paper support so that
it is approximately halfway between the two
tractors.
Open the covers of both tractors and insert the
paper so the tractor pins fit.