Printing On Fanfold Paper; Parking Fanfold Paper - Star LC-1511 User Manual

Fanfold paper
Papier continu
Endlospapier
Modulo continuo
4 mm (0.16")
Perforation
25.4 mm (1")
Ligne prédécoupée
Perforation
25.4 mm (1")
Perforazione
18 mm
(0.7")
Perforation
25.4 mm (1")
Ligne prédécoupée
Perforation
25.4 mm (1")
Perforazione
Bottom of Form
110 mm (4.3")
Fin de la page
Unterer Druckrand
Fine della pagina
19
Cut-sheet paper
Feuilles séparées
Einzelblatt
Fogli singoli
4 mm (0.16")
5 mm
5 mm (0.2")
(0.2")
First page
6.35 mm
Première page
(0.25")min.
Erste seite
Primo foglio
8 mm (0.31")
18 mm
(0.7")
Last page
Dernière page
Letzte seite
Ultimo foglio
Labels
Etiquettes
Etiketten
Etichette
Perforation
2.54 mm (0.1") min.
C
C C
C
Label
C : 2.54 mm (0.1") min.
6.35 mm
(0.25")min.

Printing on fanfold paper

When printing on fanfold paper, take care not to print
too close to the perforations that separate each sheet.
The following shows the recommended print area for
fanfold paper, cut-sheet paper and label paper.

Parking fanfold paper

It is not necessary to remove fanfold paper currently
loaded in the printer in order to print on cut-sheet
paper. Instead, simply use the following procedure to
park the fanfold paper.
Tear off the paper at a perforation so there is no
more than half a page sticking out of the front
cover of the printer.
If necessary, you can press the control panel's
ON LINE button to put the printer off-line. and
then use the LINE FEED button to feed the paper
until a perforation is just past the front cover.
Press the control panel's ON LINE button to put
the printer off-line.
Press the control panel's SET/EJECT/PARK
button. The printer automatically reverse feeds
the fanfold paper until it is no longer in contact
with the platen, which is indicated by the printer
beeping a number of times. Also, the control
panel's POWER indicator starts to flash because
paper is not loaded.
Move the release lever to the cut-sheet position.
Change the paper guide to its upright position.
You can now load cut-sheet paper into the printer
using the procedures under "Manual sheet
feeding" on page123.