Charmglow 720-0578 Assembly & Operating Instructions page 27

PROBLEM
When attempting to light my grill, it will not
light immediately.
Rotisserie burner will not light when the
igniter button is pushed.
Regulator makes noise.
Full size cover does not fit the grill.
SOLUTION
• Make sure you have a spark while you are trying to light
the burner (if no spark)
• Ensure that the wire is connected to the electrode
assembly.
• Clean wire (s) and / or electrode with rubbing alcohol
and a clean swab. Wipe with a clean cloth.
• Check to see if the other burners operate. If so. Check the
gas orifice on the malfunctioning burner for an obstruction.
• Check to see if debris is blocking the electrode.
• Check to see if there is a spark that jumps to the burner
from the electrode. If no spark is seen, check the battery
located inside the igniter button. To open turn counter
clockwise.
Remove. It was combined with #2
Is OK.
• Gently bend the electrode closer to the burner until a spark
is seen to jump from the electrode to the burner when you
push the igniter button.
• Does the infrared back burner light when attempting to
light with a match ? If not, check to ensure the gas is on.
• Vent hose on the regulator may be plugged or regulator
may be faulty.
• Ensure the vent hole on the regulator is not obstructed.
Clear the hole, close the gas control valves. Wait ten
minutes and re-start.
• Check your flames for proper performance if the flames
are not correct replace regulator.
• Cover may be incorrect for your grill. It may be a tight fit.
Ensure the cover is the correct length for your grill.
Measure it left to right. Compare to the grill's
measurement.
• Compare the location and size of the hood portion of the
cover to your grill.
• Spread the cover and allow it to relax, preferably in warm
sunlight or in a warm room.
• For grill with a side shelf bunch the cover like a sock, put
on left to right.
Trouble Shooting
continued
27