Table of Contents
Advertisement
Quick Links
738JLN (NG) & 738JLP (LPG)
WARNING
!
A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed
for the protection of children and other at-risk individuals.
WARNING: If the information in these
instructions is not followed exactly, a re
or explosion may result causing property
damage, personal injury or loss of life.
Do not store or use gasoline or other
ammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
•• Do not try to light the appliance.
•• Do not touch any electrical switch; do not
use any phone in your building.
•• Immediately call your gas supplier from a
neighbor’'s phone. Follow the gas supplier’'s
instructions.
•• If you cannot reach your gas supplier, call
the re department.
Installation and service must be performed
by a quali ed installer, service agency or the
gas supplier.
4003899-03
©2013, Miles Industries Ltd.
L
EGEND
Gravity Vent Gas Insert
Installation & Owner’'s Manual
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Miles Industries Ltd.
www.valor replaces.com
L e a v e t h i s m a n u a l
w i t h t h e a p p l i a n c e .
R e t a i n t h i s m a n u a l
f o r f u t u r e r e f e r e n c e .
Please read this manual
BEFORE installing and
operating this appliance.
This manual contains instructions to install the
ENGINE ONLY. A front is also REQUIRED to
complete this installation. A barrier screen is pro-
vided with the front. Refer to the manual sup-
plied with the front for installation.
This appliance may be installed in an
after-market permanently located,
manufactured (mobile) home where not
prohibited by local codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certi ed kit is used.
This appliance is a domestic room-heating
appliance. It must not be used for any other
purposes such as drying clothes, etc.
This appliance is suitable for installation in a
bedroom or bed sitting room.
Ce guide est disponible en français sur demande.
I N S TA L L E R
C O N S U M E R
Advertisement
Table of Contents
Related Manuals for Miles Industries Valor 738JLN
Summary of Contents for Miles Industries Valor 738JLN
- Page 1 Installation and service must be performed bedroom or bed sitting room. by a quali ed installer, service agency or the Ce guide est disponible en français sur demande. gas supplier. Miles Industries Ltd. www.valor replaces.com 4003899-03 ©2013, Miles Industries Ltd.
-
Page 2: Table Of Contents
Ceramic Bricks installation ......23 The information contained in this installation manual is believed to be correct at the time of printing. Miles Industries Ltd. reserves the right to change or modify any information or speci- cations without notice. Miles Industries Ltd. -
Page 3: Safety Precautions
Safety Precautions READ and UNDERSTAND all instructions carefully This unit MUST be used with a vent system as before starting the installation. FAILURE TO FOLLOW described in this installation manual. NO OTHER vent these installation instructions may result in possible re system or components MAY BE USED. -
Page 4: Safety And Your Fireplace
Safety and Your Fireplace Safety and Your Fireplace Please Read and Carefully Follow all Safety Warnings and Operating Instructions Contained in Your Owners Manual (Replacement Manuals are available by contacting our service department at 1-800-468-2567 or visit www.valor replaces.com). the event of accidental contact with a Please Follow These Important hot surface. -
Page 5: Owner’'Sinformation
Owner’’ s Information INFORMATION Thank You ... WARNING For purchasing a Valor by Miles Industries. Your new EXTREMELY HOT!!! radiant gas heater is a technical appliance that must be installed by a quali ed dealer. Each Valor replace •• READ the SAFETY information on pages... - Page 6 To re t the window: NOTE: This is a problem beyond Miles Industries’’ control and is not covered under warranty. 1. Hook its top part to the rebox’’ s opening ••...
- Page 7 OWNER’’S Owner’’ s Information INFORMATION Batteries 5. Replace the front or trim with the barrier screen attached. WARNING WARNING DO NOT ATTEMPT TO CHANGE THE BATTERIES FOR SAFETY PURPOSE, ensure the barrier FOR SAFETY PURPOSE, ensure the barrier WHILE THE FIREPLACE IS STILL HOT! Let the screen is re-installed on the ...
- Page 8 In the event that the safety switch is activated again, contact a quali ed service technician for inspection. Should the safety switch require replacement, only use parts supplied by Miles Industries. How to Turn Your Fireplace OFF (including pilot) First, ensure your replace is cooled BEFORE going ahead.
-
Page 9: Remote Control Operation
OWNER’’S Remote Control Operation INFORMATION Your replace remote control helps you get the comfort, convenience and aesthetics you want from your gas replace. The remote controls your replace in different ways. IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic ON/OFF can only be programmed when the function display is fl... - Page 10 OWNER’’S Remote Control Operation INFORMATION Setting the ame Use this setting when you want a particular ame level. For instance, you want to watch ames burn at their highest level and you don’’t mind if the room is too hot.
-
Page 11: Options
OWNER’’S Options INFORMATION Required Kits* Other Accessories 770ZCK——Zero Clearance Kit Venting 759EBL——Enamel Liners Approved venting accessories as per local codes. 754RSK——Rock Set Kit Inner Fronts (choose one) 760CBL——Ceramic Black Fluted Liners Conversion Kit 741——Contemporary Front with Barrier Screen 4003360 742——Traditional Cast Front with Barrier Screen 4003293 738PGK——Conversion Kit to Propane Gas 743——FenderFire Double Door Front 738NGK——Conversion Kit to Natural Gas... -
Page 12: Lighting Instructions
OWNER’’S Lighting Instructions INFORMATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instructions exactly. -
Page 13: Speci Cations
OWNER’’S Speci cations INFORMATION Approval & Codes *High Altitude Installations This appliance is certi ed to ANSI Z21.88a-2012 / I nput ratings are shown in BTU per hour and are CSA 2.33a-2012 American National Standard / CSA certi ed without deration for elevations up to 4,500 feet Standard for Vented Gas Fireplace Heaters for use in (1,370 m) above sea level. -
Page 14: Overview
QUALIFIED Overview INSTALLER This appliance, as supplied, may ONLY be installed in an existing unaltered, functioning solid-fuel burning replace with a working ue and constructed of non-combustible material. This appliance is APPROVED for installation into combustible type construction only when using the 770ZCK Zero Clearance Kit (see separate instructions packaged with the kit for details). -
Page 15: Dimensions
QUALIFIED Dimensions INSTALLER 28-5/8” (727 mm) 19-1/2” (495 mm) 12” (305 mm) or 12-5/8” (321 mm) Varies with outer trim options Optional Outer Trim or Surround sold separately 7-7/8” (200 mm) or 8-1/2” (216 mm) Varies with outer trim options 20”... -
Page 16: Clearances
QUALIFIED Clearances INSTALLER WARNING Some materials or items, although safe, may discolor, shrink, warp, crack, peel, Some materials or items, although safe, may discolor, shrink, warp, crack, peel, and so on because of the heat produced by the replace. Avoid placing candles, and so on because of the heat produced by the ... -
Page 17: Venting
QUALIFIED Venting INSTALLER Vent Location Typical Vent Installation The vent terminal must be located through the roof. This gravity vent appliance is designed to opreate when an undistrubed Terminal Cap air ow hits the outside vent terminal from any direction. Check local codes for allowable vertical vent termination. -
Page 18: Existing Fireplace Preparation
QUALIFIED Installation Planning INSTALLER Only quali ed licensed or trained personnel should install this appliance. Installer——READ THIS FIRST 1. YOU NEED TO KNOW FROM THE 9. Install the remote control system. HOMEOWNER what accessories (surround, 10. Install bricks and logs. door, etc.) will be installed with this ... -
Page 19: Appliance Preparation
QUALIFIED Existing Fireplace Preparation INSTALLER Existing Glass Doors and Wire Screens Attach Warning Conversion Plate to Existing Fireplace (label supplied loose with 738JL Existing glass doors must be permanently removed heater) prior to installing the 738JL insert. Attach the ““This replace has been converted...”” Combustible Mantels label to the existing ... - Page 20 QUALIFIED Appliance Preparation INSTALLER Venting Installation IMPORTANT: This appliance’’ s venting system requires room air to be used in the combustion process. 1. Rough-in one 3”” diameter vent liner into the existing chimney system from the roof. Be careful not to tear or damage the liner in the process.
-
Page 21: Supply Gas Installation
QUALIFIED Supply Gas Installation INSTALLER Pressure Test Points The gas supply inlet connection is a 3/8”” NPT female connector and is located on the left hand side of the The minimum supply pressure is given in the section control valve. Specifi... -
Page 22: Ignition Spark Check
QUALIFIED Ignition Spark Check INSTALLER The pilot burner and electrode unit are at the left end of the burner. Push in the lighting knob and turn it counter-clockwise through the ““IGN”” position to ““PILOT””. A spark should ash across from the pilot electrode to the pilot burner shield as shown below. -
Page 23: Ceramic Bricks Installation
QUALIFIED Ceramic Bricks installation INSTALLER The following guidelines apply for all brick liners. 4. Rotate the anchor up and out of the way and slide the right hand side panel against the rebox side. 1. Inside the rebox, on the top of each side, release Rotate the anchor back down to hold the panel. -
Page 24: Ceramic Logs Installation
QUALIFIED Ceramic Logs Installation INSTALLER Unpack the ceramic logs very carefully to avoid damaging the fragile material. Install the logs as shown below. Please note that the position of the logs is critical to ensure proper performance of the appliance. 1. - Page 25 QUALIFIED Ceramic Logs Installation INSTALLER 4. Place the front right log on the burner and slide it to 6. Place the lower end of the center right log onto the the left against the front left log. pin on the front right log. Rest the narrow end in the notch into the rear log.
-
Page 26: Window Re Tting
QUALIFIED Window Re tting INSTALLER 1. To re t the window, hook its top part to the rebox’’ s opening frame. Make sure that the wider part of the window frame is at the bottom. 2. While you hold it, push in and turn the two top spring- loaded bolts a quarter turn to engage their pin. -
Page 27: Front, Trim And Barrier Screen Installation
QUALIFIED Front, Trim and Barrier Screen Installation INSTALLER Install the front and trim chosen by the customer for their replace. Install as well the barrier screen which is provided with the front. Show the customer remove the front and also how to access the controls when the front is installed. -
Page 28: Warranty
1. Extended Warranty Coverage For a period of up to ten (10) years, Miles Industries Ltd., (the ““Company””) or its appointed distributor will at its option pay the initial purchaser for the repair of, or will exchange the following parts or components which are found to be defective in material or... -
Page 29: Spare Parts
OWNER’’S Spare Parts INFORMATION Part Part Code Description Code Description Number Number Exhaust Slide Assembly 4000127 Warning Hot Glass Plate 4003093 Port Cover 4001820AH Thermocurrent Interruptor 4000202 Log Support 4004353 GV34 Valve Assembly NG 4003096 Side Bricks Anchors (2) 4001283 GV34 Valve Assembly LPG 4003109 Top Mounting Bracket... - Page 30 OWNER’’S Spare Parts INFORMATION 35a, 35b...
- Page 31 Serial Number: Date Purchase (yyyy-mm-dd): Dealer: Customer Information First Name: Last Name: Contact Information Email: Mailing Address Address: City: Province/State: Postal/Zip Code: Country: Cut out page, ll information, and mail to Miles Industries Ltd. Online Warranty registration at www.valor replaces.com...
- Page 32 Tape Shut Fold here Postage needed Miles Industries Ltd. 190 - 2255 Dollarton Highway North Vancouver, BC V7H 3B1 Canada Online Warranty registration at www.valor replaces.com Thank you for choosing a Valor Product...
Need help?
Do you have a question about the Valor 738JLN and is the answer not in the manual?
Questions and answers