Surround Assembly; Mantel Heat Shield Assembly - Jøtul C450 Installation And Operating Instructions Manual

Tools Required:
• 10 mm socket or wrench
Right Leg
Figure 12. Surround Panel Assembly

Surround Assembly

All fasteners have already been installed in the
appropriate locations at the factory. You will need
to remove them, attach the parts together as
described below and re-install the fasteners at
those locations.
1. Layout the parts. Place the castings face down
on a protective surface such as carpeting, blan-
kets or a sheet of cardboard. See fig. 12, page 12.
2. Attach the Breastplates to each other.
Use a 10 mm socket or wrench with two M6 x 10
hex head flange bolts.
3. Attach the Leg plates. The Legs must be oriented
with the Hang Tabs on the inside edges as shown
in fig. 12. Use the two remaining M6x 12 hex
head flange bolts to attach the Legs to the
Breastplate assembly. See Fig. 12.
4. Install theTrim Rod, using the two
M6 x 10 bolts located on the Right and Left Legs.
5. Optional: Install the Wide Surround. If you will be
installing the optional Wide Surround Panels, use
the instructions included with that kit.
6. Optional: Install Mantel Heat Shield 155833.
If you will be installing the optional Mantel Heat
Shield, use the instructions included with that kit.
12
Right
Breastplate
M6 x 12 Flange Bolt
H
Hang Tab
should point
straight down
Left
Breastplate
M6 x 12 Flange Bolt
M6 x 10 Flange Bolt
Set Screw
M6 x 10 Flange Bolt
Trim Rod
M6 x 10 Flange Bolts
7. Attach the Assembly to the Firebox. Lift the
entire assembly upright and position it in front
of the insert firebox. DO NOT LIFT THE ASSEMBLY
BY THE TRIM ROD. The four Hang Tabs on the
surround legs must engage with the adjacent
holes in the two brackets on either side of the
firebox opening. The surround will easily engage
with these brackets if the firebox is slightly
proud of the fireplace opening.
Hang the surround assembly on the firebox and
push the entire unit into position so that the
surround is flush against the fireplace face.
Final leg panel alignment can be adjusted by
slightly loosening or tightening those attach-
ment bolts as necessary.
Left Leg