Connect The Wiring; Wiring Diagram; Finalize The Installation; Changing Light Bulbs - Kenmore 43813 Use & Care Manual

Range hood

Hide thumbs

Table Of Contents

Table of Contents

WARNING: Risk of electrical shock. Electrical

wiring must be done by qualified personnel

in accordance with all applicable codes and

standards. Before connecting wires, switch

power off at service panel and lock service

disconnecting means to prevent power from

being switched on accidentally.

OPTION

According to your needs, 3 soffit chimney models are

available - to hide ductwork if the hood is not installed

under a cabinet.

The 12'' high 43805 model is intended for kitchen with 8'

ceiling, the 24'' high 43806 for 9' ceiling and the 36'' high

43807 for 10' ceiling. Refer to the instructions included with

the soffit chimney.

Refer to page 5 for ordering information.

1. To install blower, refer to instructions included with blower

/ rough-in kit. Once the blower is installed, plug the blower

unit into the female receptacle and the power supply onto

the male connector inside the hood. DO NOT plug the two

cords into each other.

See page 5 for blower / rough-in kit information.

2. Install the pan previously removed inside the hood, and

secure with its 4 screws.

WARNING:

In order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed

fixtures.

This hood must use 120 V, 50W, MR16 with GU10 base or PAR 16 with GU10 base, shielded halogen lamps (included).

Refer to page 4 for ordering information.

WARNING:

In order to prevent the risk of personal injury, the halogen lamps must be cooled down before removing

them.

1. To remove lamps, gently push upwards and turn

counterclockwise to disengage bulb leads from their

grooves.

NOTE

If need be, use a rubber dishwashing glove to add grip

when removing the bulb.

2. Install the new lamps by placing the bulb leads into their

grooves in the socket.

3. Gently push upwards and turn clockwise until secure.