Connect The Wiring; Install The Filters - Kenmore 233.51403 Use & Care / Installation Manual

Hide thumbs

Table of Contents

Available languages

WARNING: Risk of electric shock. Electrical wiring

must be done by qualiﬁ ed personnel in accordance

with all applicable codes and standards. Before

connecting wires, switch power oﬀ at service panel

and lock service disconnecting means to prevent

power from being switched on accidentally.

1. Connect House Power Cable to range hood wiring: BLACK

to BLACK, WHITE to WHITE and GREEN or bare wire

under GREEN ground screw.

2. Reinstall the blower cover plate (shaded part on illustration

beside) using the lock nut and 7 screws previously removed

in step 3 on page 9. Pay attention to screw 1 location; from

back of hood point of view, it must be located on left side

of the lock nut (see inset).

Ducted Installation Only:

Re-install grease ﬁ lters removed in step 2 on page 8,

under "Prepare the Hood".