Install Electrical Plate; Connect Wiring - Kenmore 233.5230 Series Use & Care / Installation Manual

INSTALL THE ELECTRICAL PLATE
Mount the electrical plate to the hood with 2 screws (3,9 x 9,5 mm).
ELEC-
TRICAL
PLATE
CONNECT THE WIRING
Note: This range hood must be properly grounded.
The unit should be installed by a qualified electri-
cian in accordance with all applicable national and
local electrical codes.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING - Improper grounding can result in a risk
of electric shock.
Consult a qualified electrician if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
Do not use an extension cord. If the power supply
cord is too short, have a qualified electrician install
an outlet near the appliance.
Set the electrical power supply within the space
covered by the decorative flues.
Position the power socket at a maximum distance
of 33-7/16" (85 cm) from where the lead exits from
the hood (see illustration alongside). Make sure this
does not interfere with the bracket fastening area or
with the decorative flue (where the flue touches the
wall).
Fit the plug into the power socket.
8