Assembling The Pedestal - Panasonic Viera TH-P54Z10H Operating Instructions Manual

Assembling the pedestal

Remove the cable cover from the frame
●
The cable cover will be used again after the
pedestal is attached to the display unit.
Use the assembly screws
●
Make sure that the screws are securely tightened.
●
Be careful not to scratch the surface (part with gloss finish) of the base during assembly.
B
A
Securing the Display Unit
Slide the pedestal frame posts into the brackets on
the rear of the display unit.
Use the assembly screws
●
Make sure that the screws are securely tightened.
Attach the holder cover
●
Make sure that the screws are securely tightened.
Attach the cable cover.
.
to fasten securely.
C
to fasten securely.
with assembly screws
●
Place a cable in
the groove as
necessary and
attach the cable
cover.
The lower part
of the groove is
separated in right
and left. Use the
one suitable for
you.
B
Cable cover
B
A
.
Hole for the
Base installation
F
D
Cable cover
E
9