Panasonic Viera TH-P54Z10H Operating Instructions Manual page 60

FAQs
●
Due to the digital reception technologies involved, quality of the Digital TV signals may be relatively low in
some cases, despite good reception of Analogue TV channels.
Unable to receive signals
with a high-performance
aerial
Interference or
frozen / disappearing
image in Digital TV
TV goes into "Standby mode"
The remote control does not
work or is intermittent
Cannot operate the TV
Parts of the display unit or the
tuner box become hot
60
Problem
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
Aerial
Input
terminal
VCR
●
Check "Digital TV Signal Condition". (p. 37)
If "Signal Quality" or "Signal Strength" are displayed in red, check aerial.
If problem persists, consult your local Panasonic dealer.
●
Turn the TV off with the Mains power On / Off switch, then turn it
On again.
●
Remove the mains plug of the tuner box from the wall socket and
connect it again to turn it on.
●
Off Timer function is activated.
●
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 8)
●
Has the TV been switched On?
●
Has the remote control been registered? (p. 41)
●
The batteries may be running low. Replace them.
●
Use the remote control within the range of 7 m from the tuner box.
●
Keep the remote control away from the devices such as wireless
LAN, microwaves, mobile phones or other electric equipment to
avoid wave interference.
●
Turn the display unit and the tuner box off, and then on again.
●
The temperature rises will not cause any problems in terms of
performance or quality.
Actions
(Individual aerial)
Splitter
Aerial Output
Aerial Input
Aerial Output
(Individual aerial)