Listening To The Fm Radio - Teac CX-400iDAB Owner's Manual

Press the FUNCTION button to select "FM/DAB".
1
Press the FM/DAB button to select a band.
2
Select the station you want to listen to (auto selection).
3
Manual tuning
Turn the TUNING button(
that you want to hear.
Automatic tuning
Press the AUTO SCAN button to begin automatic
tuning.
To scan a higher frequency station, turn the TUNING knob
in the "UP" direction and press the AUTO SCAN button. To
scan a lower freqency station, turn the TUNING knob in the
"DOWN" direction and press the AUTO SCAN button.
When a station is tuned in, the tuning process will stop
automatically. Repeat this step until you find the station that
you want to hear.
After you tune in a station using the automatic tuning, it is
received in Mono mode. To switch to Stereo mode, press the
FM MODE button on the remote control unit.

Listening to the FM Radio

/ ) until you find the station
FM MODE button
Pressing this button alternates between STEREO mode and
MONO mode.
STEREO
FM stereo broadcasts are received in stereo and "ST"
indicator appears in the display.
If the sound is distorted and "ST" indicator blinks, the signal
is not strong enough for good stereo reception.
In this case, change to Mono mode.
MONO
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced into monaural, reducing
unwanted noise.
If the reception is poor
Extend and turn the DAB/FM antenna to improve the
reception of a station.
29