Listening To Radio Programs; Storing Preset Stations - Teac MC-D3 Owner's Manual

Listening to Radio Programs

1
2
1
Press the TUNER (BAND) button.
2 To select the band (MW or FM), press the TUNER (BAND) but-
ton again.
3 Select a station.
Hold down the TUNING button (
release the button. When a station is tuned in, the tuning stops
automatically.
Repeat this step until the desired station is found.
Press the TUNING button to stop the tuning.
< To select stations which cannot be tuned automatically, press
the TUNING button repeatedly.
< "STEREO" is displayed when a stereo broadcast is tuned in.
A If the reception is poor
Press the FM MODE button.
The unit is turned to mono mode, but the reception will
improve.
For a good reception, turn around the antenna so that you can
get the stations clearly.
14
A
3
or ) for a while and

Storing Preset Stations

1
A 3
2
Up to 20 FM and 12 MW stations can be stored in preset memo-
ries.
1 Press the TUNER [BAND] button to select FM or MW.
2 Press the TUNING button and tune in a station to be stored as
a preset station and then press the MEMORY/TIME SET button.
3 Select a preset channel to store the station by pressing the
REPEAT/PRESET UP button or a numeric button, and then press
the MEMORY/TIME SET button.
Remember not to overwrite a preset channel. It is wise of you
to write down which stations are stored in which channels.
To store more stations, repeat steps
A How to select preset stations
Press the PRESET UP button or numeric buttons to select a
preset channel.
3
2 3
1 to . 3