Toyotomi FF-V30T Installation And Operation Instructions Manual page 22

5. Move the heater into position. Attach the bent joint to
the outlet of the flue pipe and attach the bent joint to the
Fig. 10
6. Fasten the inlet hose to the inlet with the hose band.
Attach the bent joint to the flue pipe with the pipe
holder (If the extension pipe is used, also attach the pipe
Fig. 11
21
inlet. Make sure all connections are tight (See Fig. 10).
Outlet
Inlet
holder to the connection of the bent joint and extension
pipe). Attach the bent joint to the outlet by sliding the
pipe stopper into the outlet clip (SeeFig. 11).
Pipe stopper Pipe stopper
Bent joint
Inlet hose