Miele G 7893 Operating Instructions Manual page 60

Problem solving guide
Fault
White residues and/or
flecks are visible on
items.
60
Possible cause
The water softener is
programmed to a setting
which is too low.
Water entering the
machine through the AD
water connection is not
soft enough.
The salt reservoir is empty. Fill carefully with salt.
The salt reservoir cap has
not been screwed on
correctly.
The rinsing agent reservoir
is empty.
The rinsing agent dosage
has been set too low,
causing water marks.
The quality of the rinsing
water was not good
enough.
Remedy
Check the water hardness
level of the water supply
and programme the water
softener correctly.
Change the resin in the
aqua purificator.
Replace it making sure it
screws back on correctly.
Adding rinsing agent.
Increase the rinsing agent
dosage setting.
– Use water with a lower
conductivity level.
– If the washer disinfecter
is connected to a
cartridge for
demineralised water,
check its condition and
exchange it if
necessary.