Basic Installation - Lorex Road Warrior RW2S SERIES Instruction Manual

BASIC INSTALLATION

1. Insert the SDHC memory card
a. Open the SD memory slot cover (Figure 1.0).
b. Insert the SDHC memory card into the slot with
the sticker face up, and upright. Push memory
card firmly until you hear a click. The memory
card locks in place.
c. Close SD memory slot cover.
The SDHC memory card should slide smoothly
NOTE:
into the memory slot. The SDHC memory card is
designed to go in one way only. Do not force in the card.
2. Install the mounting bracket
a. Stick the double-sided adhesive onto the base of
the mounting bracket (Figure 1.1).
b. Plug the mini-jack connector from the mounting
bracket into the side of the Road Warrior labeled
GPS (Figure 1.2).
c. Slide mounting bracket upwards on the back of
the device (Figure 1.3). The mounting bracket
locks in place.
d. Connect the car adapter to the Road Warrior and
cigar lighter.
3. Mount the Road Warrior
See "Mounting your Road Warrior" on page 5
NOTE:
for mounting tips.
a. Orient the unit upright (Figure 1.4). Firmly press
the mounting bracket onto the windshield. Hold
for three seconds to secure.
b. Loosen the screws on the mounting bracket to
adjust the mounting angle. Tighten screws to
secure mounting position.
Always have a clear view of the road. Adjust
CAUTION:
the positioning of the Road Warrior so that it does not
affect your driving reflexes and traffic awareness.
Check local laws before mounting unit on windshield.
Figure 1.0 Insert SDHC memory card.
Figure 1.1 Stick double-sided adhesive to base.
Figure 1.2 Plug minijack into GPS port.
Figure 1.3 Slide mounting bracket upwards to lock.
Figure 1.4 Mount Road Warrior to windshield.
Basic Installation
3