Version Tab; Restoring User Settings - Lorex Road Warrior RW2S SERIES Instruction Manual

Configuring your Road Warrior

Version Tab

The version tab shows the version number of
Lorex Viewer and Road Warrior. This
information may be useful when you want to
confirm that you have the latest version of
Lorex Viewer and the latest firmware on the
Road Warrior.
You may need to access the Version tab for
troubleshooting purposes with Lorex technical
support.
To view what version of Lorex Viewer, and the
firmware version of the Road Warrior you have:
• Select the Version tab.
Figure 3.7 The Version tab shows what version of Lorex
Viewer you have installed.

Restoring User Settings

You can save your user settings so that you
may re-load your Road Warrior configuration
at any time.
For example, you may have to format your
SDHC memory card. Once your SDHC memory
card has been formatted, all your user settings
such as time settings, pre and post recording
times etc., will reset to the factory default.
In order to save your settings, you must save
your user settings.
Restoring Factory Default Settings
• Click
menu; click Yes to restore factory settings.
Saving User Settings
To save your Road Warrior user settings:
1. Click (setup) to open the setup
menu.
18
on the bottom of the
2. Adjust your user settings (i.e. time
settings, pre and post recording time etc.)
3. Click OK. The Save As menu appears
(Figure 3.8).
Figure 3.8 The Save As menu. Save the CFG file to a desired
directory.
4. Locate the directory you wish to save the
CFG file. Click Save.
Once you have saved your Road Warrior user
settings file, you can re-load your Road
Warrior user settings at any time.
To load your user settings file:
1. Click (setup) to open the setup
menu.
2. Click
menu. The Open menu appears.
Figure 3.9 The Open menu. You can only open CFG files.
3. Locate the .JDF you saved previously. Click
OPEN. Click OK to continue. A pop-up
menu opens. Click YES to load the JDF file.
on the bottom of the