Table of Contents
Advertisement
LOUVRE
INSTALLATION
1)
Attach the top & bottom louvres to the
side stove panel using 2 screws per
side.
Masport F39 Room Sealed Freestanding Gas Fire
FLUEING
INTRODUCTION
The DV Fire Horizontal Flue Kit and the Simpson
Dura-Flue Room Sealed System Model DV-GS
fluing systems, in combination with the Masport
Room Sealed Freestanding Gas Fire, F39-NG,
and F39-LPG, have been tested and listed as
direct flue heater systems by AGA.
These units use the "balanced flue" technology
Co-Axial system. The inner liner flues products
of combustion to the outside while the outer
pipe draws outside combustion air into the
combustion chamber thereby eliminating the
need to use heated room air for combustion and
losing warm room air up the chimney.
Note: These flue pipes must not be con-
nected to any other appliance.
The gas appliance and flue system must be
flued directly to the outside of the building, and
never be attached to a chimney serving a
separate solid fuel or gas burning appliance.
Each direct flue gas appliance must use it's own
separate flue system. Common flue systems
are prohibited.
IMPORTANT
Read all instructions carefully before starting
the installation. Failure to follow these instruc-
tions may create a fire or other safety hazard,
and will void the warranty. Be sure to check the
fluing and clearance to combustible require-
ments. Consult your local building codes before
beginning installation.
The location of the termination cap must con-
form to the requirements in the Exterior Flue
Terminal Locations diagram on page 8.
Refer to the Masport Flue Kit in-
structions supplied with each kit.
INSTALLATION
INSTALLATION
PRECAUTIONS
These fluing systems are engineered products
that have been designed and tested for use
with the F39-NG, and F39-LPG. The warranty
will be voided and serious fire, health or other
safety hazards may result from any of the
following actions:
1) Installation of any damaged Room Sealed
component
2) Unauthorized modification of the Room
Sealed System
3) Installation of any component part not man-
ufactured or approved by Masport.
4) Installation other than as instructed by
Masport.
Warning: Always maintain required
clearances (air spaces) to nearby
combustibles to prevent a fire haz-
ard. Do not fill air spaces with insu-
lation.
Be sure to check the flue termination clearance
requirements from decks, windows, soffits,
gas regulators, air supply inlets and public
walkways as specified in the Exterior Flue
Terminal Locations on page 8 and in your local
building codes.
The gas appliance and flue system must
be flueed directly to the outside of the
building, and never be attached to a chim-
ney serving a separate solid fuel or gas-
burning appliance. Each direct flue gas ap-
pliance must use it's own separate flue sys-
tem. Common flue systems are prohibited.
SAFETY
PRECAUTIONS FOR
THE INSTALLER
1)
Wear gloves and safety glasses for pro-
tection.
2)
Exercise extreme caution when using
ladders or on roof tops.
3)
Be aware of electrical wiring locations in
walls and ceilings.
7
Hide quick links:
Advertisement
Table of Contents
