HAMPTON BAY Florentine Owner's Manual page 7

Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Figure 5)
2. Remove the mounting bracket from the canopy
by removing the 1 of 2 screws from the bottom
of the mounting bracket and loosening the
other one a half turn from the screw head.
Next, turn the canopy counter clockwise to
removing the canopy cover form the canopy.
(Figure 5)
3. Remove the clevis pin, cotter pin and set
screws from the top of the motor assembly.
(Figure 6)
4. Route wires exiting from the top of the fan
motor through the coupling cover, canopy
cover, canopy and then through the ball/
downrod. (Figure 6)
5. Align the holes at the bottom of the downrod
with the holes in the coupling on top of the
motor housing (Figure 6). Carefully insert the
clevis pin through the holes in the collar and
downrod. Be careful not to jam the clevis pin
against the wiring inside the downrod. Insert
the cotter pin through the hole near the end of
the clevis pin until it snaps into its locked
position, as noted in the circle inset of Fig. 6.
4
WARNING
FAILURE TO PROPERLY INSTALL COTTER PIN
AS NOTED IN STEP 5 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
6. Tighten two set screws at top of the fan motor
collar firmly and evenly. (Fig. 6)
Motor Wires
Ceiling Canopy
Ball/Downrod
Assembly
Canopy Bottom
Cover
Cotter Pin
Ceiling
Mounting
Bracket
Ceiling Canopy
Tighten Screw
Firmly
Canopy Bottom
Cover
Figure 5
Pin in Locked
Positioon
Coupling
Cover
Clevis Pin
Motor Collar
Figure 6