HAMPTON BAY Florentine Owner's Manual page 10

Installing the Wall
Transmtter
Remember to shut the power off at the circuit
breaker or fuse box.
WARNING
HOOK UP IN "SERIES ONLY" DO NOT CONNECT
THE HOT AND NEUTRAL WIRES OF ELECTRIC
CIRCUIT TO THE TRANSMITTER WALL SWITCH -
DAMAGE TO THE SWITCH AND POSSIBLE FIRE
COULD OCCUR.
(Fig. 11) Carefully tuck the wire connections
1.
inside the junction box. Secure the wall
transmitter with the two screws provided.
2. Attach the wall plate over the wall transmitter
and secure with the two screws provided.
Switch
Screws
Wall Plate
Screws
4
3
2
1
0
Finishing the Fan
Installation
1. Tuck connections neatly into ceiling outlet
box.
Slide the canopy up to mounting bracket and
2.
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 12)
Align the circular hole on canopy with the
3.
remaining hole on the mounting bracket,
secure by tightening the two set screws. Note:
Adjust the canopy screws as necessary until the
canopy and canopy cover are snug.
Outlet Box
Figure 11
WARNING
MAKE SURE THE TAB ON THE HANGING
BRACKET PROPERLY SITS IN THE GROOVE IN
THE HANGER BALL BEFORE ATTACHING
THE CANOPY TO THE BRACKET BY TURNING
THE HOUSING UNTIL IT DROPS INTO PLACE.
Ceiling
Mounting
Bracket
Screw
Outlet Box
Screw
Canopy
Canopy
Bottom Cover
Figure 12
7