Operation - Craftsman MiterMate 137.212260 Operator's Manual

SAFETY INSTRUCTIONS FOR BASIC
SAW OPERATION
BEFORE USING THE MITER SAW
WARNING
!
To avoid mistakes that could cause
serious, permanent injury, do not
plug the tool in until the following
steps are completed:
● Completely assemble and
adjust the saw, following the
instructions. (ASSEMBLY AND
ADJUSTMENTS)
● Learn the use and function of the
ON/OFF switch, lock-off switch,
upper and lower blade guards, head
lock down knob, bevel lock handle
and cover plate screws.
● Review and understand all
safety instructions and operating
procedures in this Operator's
Manual. (SAFETY & OPERATIONS)
● Review the MAINTENANCE and
TROUBLESHOOTING GUIDE for
your miter saw.
● To avoid injury or possible death
from electrical shock:
Make sure your fingers do not
touch the plug's metal prongs
when plugging or unplugging
your miter saw. (ELECTRICAL
EQUIREMENTS AND SAFETY)
BEFORE EACH USE INSPECT YOUR
SAW.
● Disconnect the miter saw.
To avoid injury from accidental
starting, unplug the saw before any
adjustments, including set-up and
blade changes.
● Compare the direction of rotation
arrow on the guard to the direction
arrow on the blade. The blade teeth
should always point downward at the
front of the saw.

OPERATION

● Tighten the arbor bolt.
● Tighten the cover plate screw.
● Check for damaged parts.
Check for:
● Alignment of moving parts
● Damaged electric cords
● Binding of moving parts
● Mounting holes
● Function of arm return spring
● Other conditions that may affect
● Keep all guards in place, in working
order and proper adjustment. If any
part of this miter saw is missing,
bent, damaged or broken in any
way, or any electrical parts don't
work, turn the saw off and unplug it.
● Replace bent, damaged, missing or
defective parts before using the saw
again.
● Maintain tools with care. Keep the
miter saw clean for best and safest
performance. Follow instructions for
lubricating. Do not put lubricants on
the blade while it is spinning.
● Remove adjusting wrench from the
tool before turning it on.
● To avoid injury from jams,
slips, or thrown pieces, use only
recommended accessories.
● Check the dust bag before you
work. Empty the bag if it is more
than half-full.
RECOMMENDED ACCESSORIES
● Consult the ACCESSORIES and
ATTACHMENTS section of this
25 25
and lower guard: Push the
cutting arm all the way down,
then let it rise until it stops.
The lower guard should fully
close. Follow instructions in
TROUBLESHOOTING GUIDE for
adjustment if necessary.
the way the miter saw works.