Craftsman MiterMate 137.212260 Operator's Manual page 29

NOTE:
● All the adjustments for the
operation of the laser guide has
been completed at the factory.
● Laser beam is calibrated and set
up to project to the left of the blade.
(Fig. Y)
● If you have any problem or
question on the laser guide, please
call the Sears Service Center.
Fig. Y
laser beam
laser beam
top view
AVOID DIRECT EYE CONTACT

WARNING
!
● Laser is radiated when laser
guide is turned on. Avoid direct
eye contact. Always un-plug the
miter saw from power source
before making any adjustments.

DANGER
!
● Laser Warning Label:
Max output < 5 mW DIODE
Wavelength: 630-660nm,
Complies with 21CFR 1040.10 and
1040. 11.
Max.Output <5 mW Wa
Complies with 21 CFR 1040.10 and 1040.11
cutting line
workpiece
blade
cutting line
LASER RADIATION-AVOID
DIRECT EYE EXPOSURE
velength: 630-660 nm
(Fig. Z)
● Laser Aperture Label:
AVOID EXPOSURE: Laser
radiation is emitted from this
aperture. (Fig. Z)

WARNING
!
● Use of controls or adjustments
or performance of procedures
other than those specified herein
may result in hazardous radiation
exposure.

WARNING
!
● The use of optical instruments
with this product will increase
eye hazard.
● Do not attempt to repair or
disassemble the laser.
If unqualified persons attempt to
repair this laser product, serious
injury may result. Any repair
required on this laser product
should be performed by a Sears
or other qualified service center.
NOTE: All the adjustments for the
operation of this machine have been
completed at the factory.
Fig. Z
Laser
Warning
Label
29 29
Laser
Aperture
Label