Tools Needed For Assembly - Craftsman MiterMate 137.212260 Operator's Manual

TOOLS NEEDED FOR ASSEMBLY

Supplied
Blade Wrench
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over (see dotted figure).
Draw light line on
board along this edge.
Adjustable Wrench
Hex Wrench
Combination Square
Should not gap or overlap when square
flipped over (see dotted figure).
Not supplied
Square Bar
Straight edge or a 3/4 in. board, this
edge must be perfectly straight.
12 12
Phillips Screwdriver
Slotted Screwdriver