How To Operate - Panasonic CW-C180BN Service Manual

CW-C180BN

HOW TO OPERATE

CW-C180BN, CW-C240SN (Cooling Only)
Illustration
only for
CW-C180BN
1
. Power Supply
Set the Main Control Knob to the "
position; confirm that the power supply cord is
connected to a proper AC outlet.
Recommended
Use the air conditioner under
the following conditions:
• Operating temperature range.
D.B.T. W.B.T. D.B.T. W.B.T.
Maximum
Temperature
Minimum
Temperature
W.B.T.: Wet Bulb Temperature
• Humidity does not exceed 90%.
Continuous operation at over 90% humidity
may create condensation and waterdrops on
the intake and outlet vents.
°C
" OFF
(unit in °C)
Indoor unit Outdoor unit
32 23 43 26
21 15 21 15
D.B.T.: Dry Bulb Temperature
2
. Open the
cover
3
. Main Control Knob
Set to either "
COOL as required.
(FAN setting operates the fan only.)
* Caution: If the Main Control Knob is turned
off or changed to a fan setting from a cooling
operation setting, WAIT at least 3 minutes
before resetting to a cooling operation.
4
. Thermostat Control Knob
Set the Thermostat Control Knob at the
desired setting. (Usually "
recommended setting position.) If the room
temperature is unsatisfactory after a
reasonable amount of time, turn the control
knob clockwise to cool the room more, or
anticlockwise to cool the room less.
• When the Thermostat Control Knob is set to
" ", moisture may freeze onto the coils and
prevent effective cooling. If this happens, turn
the knob to "
control knob anticlockwise. This will quickly
defrost the cooling coil so that normal cooling
can be resumed.
5
. Air Swing Switch
(Airflow direction adjustment
Side-to-Side)
For fixed side-to-side air direction, set the Air
Swing Switch to "
direction is obtained, then move it to "
For continuous side-to-side air circulation, set
the Air Swing Switch to "
there.
– 8 –
" LOW COOL or " " HIGH
~ " is a
" HIGH FAN, and the thermostat
" ON until the desired air
" OFF.
" ON and leave it