How To Operate; Operation Modes - Panasonic CS-ME7EB1E Operating Instructions Manual

HOW TO OPERATE

Auto, Heat, Cool, Dr y
1
Select the
desired
operation.
Powerful and Quiet operations could be activated in all

operation modes.

OFF/ON
Press button again to stop the operation.
Hint
Heat is obtained from outdoor air to warm up the room. Use additional heater when outdoor ambient temperature is low.
Troubleshooting
Power indicator blinks.
Operation delayed for a few minutes after restart.
Sounds like water flowing during operation.
Cracking sound can be heard during operations.
Occasionally knocking sound is heard.
OFF/ON / / O O
MODE
FAN SPEED
POWERFUL AUTO
AIR SWING AIR SW W IN N G
QUIET
MANUAL
TIMER
ON SET
1 2 3
OFF CANCEL
CHECK CLOCK RESET
INVERTER
2
Start the
operation.
3
Set the
temperature.
(16°C ~ 30°C)
The operating mode is different from other indoor unit.
This is a normal self protection control.
Caused by refrigerant flow inside.
Panel expanding/contracting due to change in temperature.
Switching over of refrigerant gas in the system during defrosting and at
the end of operations.
Operation Details
AUTO - Automatic Operation
• The unit will automatically select
the operation mode according
to the setting, outdoor and room
temperature. During operation mode
selection, power indicator blinks. For
every 3 hours, the operation mode is
reselected.
HEAT - Heating Operation
• Enables you to enjoy the warming
effect at your preferred setting
temperature.
• For cold air prevention, air might
not blow out immediately and power
indicator blinks when operation
starts.
• Also operates in defrost mode
(maximum 12 minutes) where by the
power indicator blinks. The melted
frost is drained at outdoor unit and
indoor fan is stopped.
COOL - Cooling Operation
• Enables you to enjoy the cooling
effect at your preferred setting
temperature.
DRY - Soft Dry Operation
• Enables you to set the desired
temperature at low fan speed which
provides you with the dehumidifying
surroundings.
5