Whole-House Mode; Playing The Same Source At All Keypads; Do Not Disturb Mode - Linear Encore User Manual

Whole-house Mode

Playing the Same Source at all Keypads

SOURCE button for about
• Press the
three seconds to enter or exit whole-house
mode.
• The selected audio source indicator will
blink on and the same audio will play at all
keypads.
• If a keypad is set for do not disturb mode, it
will not play the source (see below).
• The volume control is independent for
each keypad.
SOURCE button on any
• Pressing the
keypad will change the audio source;
1, 2, 3, or 4 for all keypads that are in
whole-house music mode.
• Audio from local audio wall plates (source
cannot be the whole-house source.

Do Not Disturb Mode

• Press a keypad's
three seconds to prevent the individual
keypad from allowing whole-house mode.
• The keypad will flash to display that if
whole-house mode is selected by another
keypad, this keypad will not participate.
• To allow whole-house mode for the keypad,
press the MUTE button again for about
three seconds.
MUTE button for about
System Operation
L)
PRESS SOURCE BUTTON
FOR 3 SECONDS
SELECTED SOURCE
LIGHT WILL BLINK
SELECTED SOURCE
LIGHT WILL BLINK
ON ALL KEYPADS
IN WHOLE-HOUSE MODE
EACH KEYPAD HAS
INDEPENDENT VOLUME
CONTROL
PRESS MUTE BUTTON
FOR 3 SECONDS TO
DISABLE WHOLE-HOUSE
MODE FOR A KEYPAD
VOLUME LIGHTS
WILL FLASH
7