Upper Handle Positioning - Mantis 7567 Operator's & Parts Manual

UPPER HANdLE ASSEMBLy
10
• With a 7/16 in. (11 mm) spanner and
socket, tighten the nuts and bolts that
hold the brace onto the handles.
13
• Lift the upper handles until they line
up with the lower handles and fully
tighten the knobs at the pivot point.

UPPER HANdLE POSITIONING

1
• Adjust your handle height by loosening the
upper 2-prong knobs and removing the
round knobs then sliding the upper handles
to the desired position.
Improper Throttle installation can cause tines to rotate unexpectedly.
Contact us at www.mantis.uk.com or your local authorised Mantis
(cONTINUEd)
11
• Insert the carriage bolts into the bottom
holes of the upper handles then through
the top holes of the lower handles.
14
• Cap the exposed bolts with the acorn
nuts and tighten with your 7/16" (11
mm) spanner until snug. Do not over
tighten.
2
• Then re-insert the round knobs and re-
tighten the 2-prong knobs.
12
• Loosely thread the other 2-pronged
knobs onto the carriage bolts.
15
• Attach the throttle cable clips to
the upper and lower handles.
Make sure the cable is not
wrapped or twisted and you have
the proper throttle movement.
* See important notes listed below.
IMPORTANT NOTE:
Before you use your Mantis
the Safety Rules & warnings on pages 4-6
Assembly
deluxe XP Tiller, read
®
Dealer 11
®