Upper Handle Positioning; Upper Handle Assembly - Mantis 7566 Operator's & Parts Manual

UPPER HANdLE ASSEMBLy

10
• With a 7/16 in. wrench and socket,
tighten the nuts and bolts that hold
the brace onto the handles.
13
• Lift the upper handles until they line
up with the lower handles and fully
tighten the knobs at the pivot point.

UPPER HANdLE POSiTiONiNG

1
• Adjust your handle height by loosening the
upper 2-prong knobs and removing the
round knobs then sliding the upper handles
to the desired position.
improper Throttle installation can cause tines to rotate unexpectedly.
Contact us at mantis.com or Your Local Authorized Mantis
401780 Mantis XP Deluxe tiller manual.indd 11
(cONTiNUEd)
11
• Insert the carriage bolts into the
bottom holes of the upper handles
then through the top holes of the
lower handles.
14
• Cap the exposed bolts with the acorn
nuts and tighten with your 7/16"
wrench until snug. Do not over tighten.
2
• Then re-insert the round knobs and
re-tighten the 2-prong knobs.
12
• Loosely thread the other 2-pronged
knobs onto the carriage bolts.
15
• Attach the throttle cable clips to
the upper and lower handles.
Make sure the cable is not
wrapped or twisted and you have
the proper throttle movement.
* See important notes listed below.
iMPORTANT NOTE:
Before you use your Mantis
the Safety Rules & warnings on pages 4-6
Assembly
deluxe XP Tiller, read
®
Dealer 11
®
1/24/13 4:07 PM