Rear - Sony UP-CX1 Operating Instructions Manual

Flashing: When the paper roll or ribbon cartridge run out
while printing is in progress, the indicator begins
flashing after you replace them. Press the RESET
button after replacement, and the indicator turns off.
f ON/STANDBY button
Press this button to turn on power to the unit. Press it again
to enter the standby mode.
To restart the unit from standby mode, wait at least 5
seconds in standby mode, and then press the ON/
STANDBY button.
g CLEANING button (page 17)
Press this button to perform cleaning.
h RESET button
When the paper roll or ribbon cartridge run out while
printing is in progress or an error occurs, press this button
to resume printing after the problem has been resolved.
i Eject slot
The printed photo emerges from this slot.
j Paper tray (page 13)
Printed photos are collected in this tray.
k Paper eject stopper (page 14)
When using the print pack 2UPC-C13, this stopper should
be raised.
l Front door (page 9)
Open this door to change the paper roll.
Front door open
A
A Paper holder (page 9)
The paper roll is inserted here.
The white areas between printouts are cut off and
collected in the top portion of the paper holder.
B Paper holder release button (page 9)
Press this button to remove the paper holder.
m Side door (page 11)
Open this door for replacing the ribbon cartridge.
B
Side door open
A
A Ribbon cartridge access opening (page 11)
Mount the ribbon cartridge here.

Rear

1
2
a USB port (device) (page 7)
Use a commercially available USB cable to connect the
unit to a computer.
Operation is not guaranteed when connected by a USB
hub.
b ~ AC IN (Power Source) Connector (page 7)
Connect the power cord here.
c Air vent
Features a built-in filter for the thermal head cooling fan.
3
5
Controls and Functions