Sony UP-CX1 Operating Instructions Manual page 18

9
The adhesive surface of the cleaning sheet is exposed
now, so check again to make sure that none of the
corners have peeled up.
10
Press the CLEANING button again.
The CLEANING indicator remains lit, and cleaning
begins. The print paper is fed in and out of the eject
slot, removing any dust or other particles inside the
printer in the process.
When cleaning is complete, the print paper is cut
multiple times, and the CLEANING indicator begins
flashing again.
Make sure that the entire cleaning sheet has been
ejected. If there are any portions of the cleaning sheet
remaining in the printer, remove the paper holder, and
cut off the remains.
11
Remove the cleaning cartridge, and replace the ribbon
cartridge.
Notes
• A small amount of paper is necessary to perform
cleaning. If the remaining amount of paper is too low, an
error may occur. In such a case, replace the paper roll
and perform cleaning again.
• Paper used during cleaning is cut automatically.
When the printer roller becomes dirty
When the printer roller becomes dirty, use a soft cloth
moistened with cleaning alcohol to gently wipe the roller
while turning it.
18
Precautions
Note
When cleaning the printer roller, always put the printer
into standby mode with the ON/STANDBY button, and
disconnect the power cord.
When the cabinet becomes dirty
If the cabinet is extremely dirty, soak a clean cloth in
water, or a solution of water and a neutral detergent, wring
out the cloth, and then wipe the surface of the cabinet.
Next, wipe clean with a clean, dry cloth.
To avoid damaging the surfaces of the unit, never use
thinner, benzene, alcohol, or any other type of organic
solvent to clean the unit.
When the filter for the cooling fan
becomes dirty
When the filter for the thermal head cooling fan has
become considerably dirty, remove it and rinse off the dirt
with water. Do not scrub the filter mesh with a brush or
other cleaning tool.