Terminal Panel Features - NEC MultiSync LT 100 User Manual

Terminal Panel Features

This panel is located in the side and is where you connect your cables.
1 Remote Control Jacks
a. Remote Control Input Jack
Connect your remote control cable here for wired operation.
b. Remote Control Output Jack
This terminal enables you to operate up to five projectors with the
same remote control. When your remote mouse receiver is con-
nected here, the remote sensors on the projector cabinet will re-
ceive your mouse commands.
2 Video Input
Connect a VCR, laser disk player, or document camera here to
project video.
Left Channel/Mono Audio Input Jack
This is your left channel audio input for stereo sound coming from
video equipment or audio system. This also serves as your mon-
aural audio input.
Right Channel Audio Input Jack
This is your right channel audio input for stereo sound.
S-Video Input
Here is where you connect S-Video input from an external source
like a VCR.
NOTE: S-Video provides more vivid color and higher resolution than
the traditional composite video format.
3 PC Control Port
Use this port to connect your PC to control the MultiSync LT100
Projector. This enables you to use your PC and serial communica-
tion protcol to control the projector. If you are writing your own
program, command reference are on pages 97 to 100.
4 RGB Input Connector (Mini D-Sub 15 pin)
Connect your PC or other RGB equipment such as IBM or com-
patible computers. Use the signal cable that's supplied to connect
to a PC. This also serves as the Y/Cb/Cr input connector which
allows you to connect a DVD player with the component video
output.
RGB Audio Input Mini Jack
This is where you connect RGB audio output from a computer or
another RGB source.
INTRODUCTION
2
1
INTPUT VIDEO INPUT
S-VIDEO VIDEO L ( MONO
OUTPUT RGB INPUT
REMOTE
CONTROL RGB AUDIO
4
21
3
PC CONTROL
) -R-AUDIO
RGB OUTPUT
RGB AUDIO
22